Sram Red AXS E1 disc brake | ED-RED-E1

The new Red AXS disc brakes, significantly lighter with a slim lever, milled caliper and now featuring buttons to control your ANT+ devices.

Brake with just one finger from the lever body or in the sprint position. 83 g lighter than the previous generation. AXS-compatible for easy setup, personalisation and reliability. eTap shifting logic for intuitive shifting. Bonus button allows control of ANT+ devices or provides an additional shifting option. Optimised grip body shape for a wide range of hand sizes. Carbon brake levers for low weight. Textured shift paddles and grip rubbers for control and comfort. Bleeding Edge technology for easy and clean bleeding. Grip width adjustment to suit different hand sizes. Pressure point adjustment for individual customisation

Contents of the Sram Red AXS E1 HRD Disc disc brake:

• Sram Red AXS E1 HDR Disc right-hand shifter
• Sram Red AXS E1 Flatmount disc brake with brake pads
• 95cm hose length
• Mounting bolts

The disc is delivered pre-assembled and bled. On request, we can cut the hose to the correct length for your bike and then bleed the brake again, subject to an additional charge.

Sram Red AXS Shifter HRD

Now true one-finger braking is possible. The lever body and lever have been completely redesigned. As a result, Sram has achieved a breakthrough in fit for all hand sizes and in brake operation, which can be actuated easily and powerfully from any position on the handlebars. The independent grip width and pressure point adjustment allows for individual customisation. There is no risk of pinching your fingers or bumping them against the handlebars, regardless of the setting you have chosen. Improved finger guidance on the lever body reduces fatigue on long days in the saddle, and with the bonus buttons you can switch or control ANT+ devices using your thumbs. The brake caliper is not only stiffer but also lighter and has phenomenal pad clearance for smooth operation. And yet we’ve managed to shed 83 g from the set.

Flat Mount brake caliper:

The new Flat Mount caliper standard for road bike brakes reduces weight and offers a significantly sleeker look. With the Flat Mount standard, the rear caliper sits directly on the chainstay; no adapter is required for caliper mounting. The bolts pass through the chainstay from below directly into the brake caliper. A flat adapter is still required on the fork. The adapter is screwed onto the rear of the fork leg, with the brake sitting directly on the adapter. By rotating the adapter, the available brake disc sizes of 140 and 160 mm can be changed.

Sram Red eTap batteries:

Batteries are used on the rear derailleur and the front derailleur. These batteries can be swapped between the two. So, for example, if the rear derailleur runs out of power halfway through a ride, you can shift to your preferred chainring at the front, swap the two batteries, and then carry on riding without any worries. The batteries have a capacity of approximately 1,000 kilometres or 60 hours of riding time. The charging time for a battery is around 45 minutes. In addition, all components of the SRAM Red eTap groupset are equipped with LED indicators. Green means the battery is fully charged, and red indicates that there is still sufficient capacity remaining. Only when the LED starts flashing red does the charge level approach the end, leaving around 5 per cent capacity remaining.

Herstellerinformation: SRAM, 1000 W Fulton Market #4, 60607 Chicago, Illinois, United States, http://www.sram.com | Contact EU: SRAM Europe Sales and Services B.V., Paasbosweg 16, 3862 ZS Nijkerk, Netherlands, https://www.sram.com