Disctube 2.2 Magura

The Magura disc brake hose with an ETT connector, 2500 mm in length.

The ETT high-pressure hoses can be fitted to all MT, Gustav Pro, Clara and Louise Elite brakes. The Easy Link fitting is permanently crimped and requires an additional brake lever with the Easy Link valve. The ETT Banjo M5 connection set is then required on the brake caliper.

Compatible with all Magura disc brakes except Magura MT2 and MT Sport. These operate with a low-pressure system and require different hoses

Also compatible with Magura CMe ABS, MT5 ABS and MT C5 ABS brakes and connection to the Integral Braking System.

Magura disc brake hoses are fabric-reinforced, high-pressure-resistant and can be easily shortened.

MAGURA EASY TUBE TECHNOLOGY (ETT):

For a long time, brake hoses were a rigid proposition for dealers and end customers. With EASY TUBE TECHNOLOGY, MAGURA now presents a new technology for the flexible creation of hose connections. All that is required is a hose sold by the metre and the corresponding ETT connection sets. In particular, the technology enables the simple creation of MAGURA EASY LINK connections for the GUSTAV PRO or MT disc brakes with EASY LINK adaptors. Particularly in specialist shops, the ETT range is not only more flexible but also less wasteful. Previously, MAGURA offered only 2.5 m long brake hoses in the aftermarket. However, when used on the front wheel, only approx. 0.8 m was required. With the new ETT connectors, dealers can now cut their requirements to the nearest centimetre from a roll of hose and use them flexibly. End customers also benefit from greater flexibility.

ETT hose connectors for brake levers:

To connect a brake line to a brake lever, MAGURA now offers a modern alternative to the classic clamping ring connection in the form of the new EASY LINK. EASY LINK is used on the MAGURA GUSTAV PRO, the Bosch eBike ABS control unit and the MAGURA Cockpit Integration (MCi). EASY LINK speeds up and simplifies the initial installation of brakes and also allows for tool-free opening and disconnection.

To create the EASY LINK fittings on the brake line, MAGURA offers a crimped and a threaded ETT version. The threaded version is characterised by particularly simple handling without the need for special tools. The set consists solely of a fitting to be pressed into the line, a slotted clamping ring and a union nut.

For the crimped version, MAGURA offers a mechanical and an electronic crimping tool.

EASY LINK is no longer reserved for specific brakes. With the help of the new EASY LINK adapters, brake levers from the MT and MT C series can also be retrofitted with EASY LINK. ETT hose connections for brake calipers Screw-on ETT connections can also be used to connect brake calipers. MAGURA offers ETT connection sets for brake calipers with a banjo connection (GUSTAV, CMe, MT4 to MT8) as well as for brake calipers with a straight M6 connection (MT SPORT, MT2, MT4, MT C).

Herstellerinformation: Magura, Stuttgarter Straße 48, 72574 Bad Urach, Germany, http://www.magura.com